Analyzer State

The Analyzer state, calibration and measured data can be saved on the hard disk to an Analyzer state file and later uploaded back into the Analyzer program. The following four types of saving are available:

State		The Analyzer settings.
State & Cal		The Analyzer settings and the table of calibration coefficients.
State & Trace		The Analyzer settings and data traces⁵.
All		The Analyzer settings, table of calibration coefficients, and data traces¹.

The Analyzer settings that become saved into the Analyzer state file are the parameters, which can be set in the following submenus of the softkey menu:

- - All the parameters in Stimulus submenu;
  - All the parameters in Measurement submenu;
  - All the parameters in Format submenu;
  - All the parameters in Scale submenu;
  - All the parameters in Average submenu;
  - All the parameters in Display submenu except for Properties;
  - All the parameters of Markers submenu;
  - All the parameters of Analysis submenu;
  - Ref Source and System Correction parameters in System submenu.

To save and recall a state file, you can use ten softkeys labeled State01, ... State10. Each of the softkeys correspond to a *.sta file having the same name.

To have the Analyzer state automatically recalled after each start of the instrument use Autorecall.sta file. Use Autorecall softkey to save the corresponding file and thus enable this function.

To disable the automatic recall of the Analyzer state, delete the Autorecall.sta file using the specific softkey.

You can save and recall the files with arbitrary names. For this purpose use File... softkey, which will open the Save as dialog box.

Analyzer State Saving

		To set the type of saving, use the following softkeys:
		To save the state, use the following softkeys:
…		To save a state into one of the ten files, use State01…State10softkeys.
		To save the state, which will be automatically recalled after each start of the Analyzer, use Autorecall softkey.
		To save a state into the file with an arbitrary name use File... softkey.

Analyzer State Recalling

		To recall the state from a file of Analyzer state, use the following softkeys:
…		Click the required softkey of the available State01…State10.
		You can select the state automatic recall file by clicking Autorecall softkey.
		To recall a state from the file with an arbitrary name, use File... softkey.

Session Saving

When enabled, this function automatically saves a session on exit and resumes it when the Analyzer is turned on next time. The stored session parameters include the Analyzer settings, table of calibration coefficients, and data and memory traces.

		To enable the Save Session function, use the following softkeys:

⁵. When recalling the state with saved data traces, the trigger mode will be automatically set to «Hold», so that the recalled traces are not erased by the currently measured data. ↩